Transmission liquid is one of the most important consumables in your automotive system. It is the durable lubricant the coats all moving parts of your Ford automobile transmission, and also when it runs low or becomes as well dirty, it have the right to cause sped up wear on infection parts and make changing gears feeling rougher 보다 usual. It"s a an excellent idea to inspect the level of transmission fluid whenever you prevent to gain a tank the gas. If it"s low, you deserve to add more yourself, but if it"s dirty, take it the auto to a mechanic to obtain the liquid changed.


Under The Hood:

How to inspect the Transmission fluid on a C4

Park the car on a level surface. Checking the fluids when its on one incline leader to improper readings. Make certain the engine is cool. If the car has been pushed recently, wait at the very least 30 minutes prior to checking the liquid levels. Heat causes the transmission fluid to expand, which also causes incorrect readings.

You are watching: 2002 ford explorer transmission fluid dipstick location


Pop the hood through pulling the hood-release lever under the steering panel. Press the hood increase the remainder of the method and progressive the stress bar to host it in place.

Locate the infection dipstick in the engine. The ar varies from automobile to vehicle, yet it is typically located between the battery and also the air intake. Watch in the owner"s hands-on or call the dealer for an ext specific details on ar of the dipstick.

Remove the transmission dipstick through pulling it directly up. Wipe turn off the dipstick v a rag. Place it ago in the tube and pull it out again. Look in ~ the transmission level top top the steel stick. It need to be at least midway between the MIN and MAX lines. If it is below the halfway point, it requirements to be refilled. Include 1/2 a quart in ~ a time into the tube through a funnel.


Items you will certainly need

Rag


How to check the Transmission liquid in a Ford Explorer

Start the Explorer, boring the parking brake and also open the hood. Locate the infection dipstick and pull it out. The infection dipstick should have actually the indigenous “transmission” or the abbreviation “trans” created on the handle. Wipe the fluid fully off the dipstick and also reinsert it completely into the infection dipstick tube.

Get into the Explorer’s driver seat and put her foot steady on the brake pedal, pushing it down as far as possible. Transition the transmission from park, down through all the gears, allowing it to fully shift into each gear before moving come the next. Transition back come park, stopping in each gear briefly top top the way back.

Get out and also pull the infection dipstick out once again and look for the liquid level top top the stick. It must land in the crosshatched area. If that is listed below this area, placed the funnel in the dipstick tube and include transmission fluid, no an ext than a pint in ~ a time, till the liquid comes up right into the crosshatch. Make certain the liquid you add is the proper kind for your year and also model Explorer. Carry out not mix transmission fluid types.


Items you will need

Ignition key

Rag

Funnel

Transmission fluid


How do I examine the Transmission fluid in a 2002 Ford Taurus?

Drive the car for number of miles or till the engine has reached its common temperature, as suggested by the temperature gauge.

Position the auto on a flat surface, change the infection to the “Park” position and also apply the parking brake.

Raise the hood and enable the auto to idle.

Withdraw the transmission’s dipstick. The dipstick features a T-shaped manage with the native “Trans. Fluid” stamped into the optimal of the handle.

Wipe the dipstick clean of any type of transmission liquid with a clean shop rag. Together the vehicle is driven, transmission liquid may splash onto the dipstick, causing a false liquid level reading.

Insert the dipstick right into its tube until the handle rests securely versus the peak of the tube, then withdraw the dipstick and note the fluid level. The fluid level should be at or just listed below the “Warm Full” mark stamped into the dipstick. If the level is low, fluid must be added.

Add Mercon V transmission fluid in small increments to stop overfilling the transmission. Insert a funnel into the top of the dipstick tube, then pour the transmission fluid into the funnel, periodically checking the liquid level ~ above the dipstick.


Items you will certainly need

Clean shop rag

Mercon V infection fluid

Funnel


How to check the Transmission liquid in a 2000 Ford F250 Powerstroke Diesel

Automatic Transmission

Drive the truck till it reaches operation temperature -- about 20 miles.

Park top top a level area and apply the emergency brake. Ar your foot on the brake pedal and also move the change lever though each gear. Enable ample time to permit the equipment to communicate in each place on the quadrant.

Place the gear selector in park and leave the motor running.

Open the hood and locate the infection dipstick tube on the passenger next of the engine near the firewall. Pull the dipstick from the tube and wipe the finish of the clean v a lint-free cloth. Insert the dipstick back into the tube till it fully seats.

Pull the dipstick back out the the tube and observe the liquid level. Keep in mind that the transmission liquid level have to be in between the two marks on the "Hot" ar of the dipstick.

Manual Transmission

Turn the engine off and apply the emergency brake.

Slide under the truck and also locate the filler plug top top the side of the infection case.

Clean the filler plug and also the bordering transmission situation with a rag to protect against dirt particles from entering the situation when you eliminate the plug.

Remove the plug through a wrench. Peer into the hole. Note that the transmission fluid level must come up to the bottom the the hole.

Replace the filler plug and also tighten it with a wrench.

How to inspect Transmission liquid on a Ford Taurus

Check her owner"s manual to find out what great of transmission fluid is recommended for your Taurus. Tauruses of various model year and alternatives packages contact for various grades that lubricant. Additionally note in the hand-operated the under-hood diagram, which identify the dipstick for transmission fluid on the rear left next of the engine.

Start the car and also drive it approximately for at least 10 mile or 20 minutes to gain it fully warmed up and lubricated. Integrate this task with various other errands so girlfriend don"t garbage gas. If you don"t already have transmission liquid or a funnel, journey to one auto-supply save to operation in and also get some.

Park the car on together level a surface ar as you deserve to find and leave the running. Traction the hood-release lever, open up the hood and prop it up through the support arm. Be careful not come touch the engine, which will certainly be hot, as you look carefully at the behind left edge of the engine block. You must see a plastic ring atop a thin steel pipe. This is the transmission-fluid dipstick. Don"t confuse it through the oil dipstick, i m sorry is at the front facility of the engine.

Carefully pull the end the dipstick, wipe it clean with a rag and reinsert it. Make certain it"s thrust in every the way, then pull it out again come look at it.

Look for the line marked "Warm full." If her Taurus has an after-market transmission-fluid dipstick, it may not be significant with separate full lines for heat or cold engines, but most of this dipsticks do. If your transmission-fluid level is not as much as this line, you need to add more. You should likewise take keep in mind of its color and smell. If the looks very dark or smells favor it"s burnt, it must be changed. In this event, don"t bother adding more unless it"s an extremely low, and also take it come a mechanic soon for a transmission-fluid flush and change.

See more: Wh A Number Between 0 And 1 ? Find Nine Rational Numbers Between 0 And 1

Add an ext transmission liquid if necessary. You must use a funnel with a long, functional tube to pour the fluid in through the dipstick hole. You have to only execute this through the engine running, and also you need to be mindful to add the fluid just a small at a time. Around an ounce at when is good. After including some, wait a minute or so for it to cycle through the transmission, then check the level with the dipstick again. It"s vital to execute it this method because it"s difficult to bleed the end transmission liquid if you include too much, and including too lot can reason serious transmission problems.