six cylinder two wheel drive automatic 93,000 miles.

You are watching: 2003 hyundai santa fe 2.7 crankshaft position sensor location

wherein is the crankshaft sensor situated on this car? i cannot discover it. Perform I must remove the intake? I watch wires walking under the intake yet cannot phone call what they room for.
*

The crankshaft sensor is located at the former of the engine down at the timing belt pulley. You will must remove the time belt cover. Below is a chart to aid you check out what ns am talk about. The six. Right here is a guide that can offer you an ext information ~ above the job:https://www.centregalilee.com/articles/crankshaft-angle-sensor-replacementHere is what it will certainly be prefer (below) because that four and also six cylinder engines.Please let us understand what happens.Cheers
*

*


ns looked for around an hour last night in this area and also could not uncover it. Is that under something else or hidden? I have actually the brand-new sensor and also know what that looks like, yet cannot check out it ~ above the car. I went to the Hyundai dealership and asked a mechanic. The crankshaft sensor is over the starter on the next of the block. A bit difficult to acquire to, yet I adjusted it and also car is running again.

I want to situate the sensor, and possibly check out the part number. Or if any type of one knows how to kindly assist me?
The crankshaft sensor is in the side of the block, behind the exhaust manifold.
*
Part#391803E100 $74.27
Hey MUSA, The crankshaft place sensor is in the next of the block, behind the exhaust manifold.Here is a diagram to aid you situate it:Please allow us know what you find so that will help others.Best, Ken
four cylinder former wheel journey manual. Wherein is the crankshaft place sensor and also how lengthy does it take to replace on a 2.4L?

*

*

Note:Part and labor may vary in ~ location.https://www.centregalilee.com/kpages/auto_repair_manuals_alldata.htm
mine 2004 Hyundai Santa Fe will certainly not start. I currently installed a new fuel pump and also still same. I was thinking may be the crankshaft sensor yet I perform not recognize where it is. How can I discover it?
You do not adjust parts and hope that it works. It is walk to be costly and also a garbage of time and money uneven you are very lucky.You should start with diagnostics to find out what is missing causing the non starting.
mine SUV suddenly would not shift into second gear going down the highway. I babied the home and also noticed also that placing it in reverse the engine automatically quit. Idle the car and also it is fine. Placing that in drive it jumps. So i took out my computer inspect tool and also it said the crankshaft sensor was bad.So ns guess I require to understand where this is located on the engine? Thanks, note
ns doubt the is your crank sensor, yet here is location in picture. If it still go it have a transmission professional inspect it. It may be a governor or in need of infection rebuild.
factor I said the sensor is mine tester offered me the p003 and said crankshaft place sensor. Someone told me that ns would have to remove the timing belt cover and crankshaft pulley. Girlfriend are showing the sensor at the top of the engine?
Hello, On my Car, we Were at A Stoplight about To revolve Left and The auto Stalled Out. It would certainly Not Start best Away, but After Pushing...
The vehicle Starts and Runs around 10 Seconds and Then just Stops, The Crankshaft Sensor and also Timing Belt Were adjusted At Shop critical Week, Could...

See more: How To Open Gas Cap On Chrysler 200 & 300, How To Open The Gas Cap On A Chrysler 300


Is there A Sensor the The computer system Wants info From ~ The Engine has actually Been to run For 3 Seconds?
My auto Does not Switch Off right Away and I need to Stall The Engine To rotate It Off. ~ I revolve The an essential To off The Engine go A...