Hello, The inertia switch is located below the tool panel, come the ideal of the infection hump. Here is a diagram (below) You must pull the carpet back. You re welcome let us understand if you need anything else to get the difficulty fixed.


You are watching: Inertia switch 2002 ford ranger 2.3

*


van no start, yet turns over, lack of gas, located collision shut turn off switch to fuel pump, will not reset, what next, have actually tried with key off and on, have actually removed 2 cable clip and also re installed, switch is located at carpet levelpassenger side below heater housing, reportedly the fuel pump is no engaging come pump mode, plastic button will not stay down, was functioning fine forever, just would not start, so an initial choice fuel and shut turn off switch, was no bumped to my awareness.

Ok, pressed down reset switch on the fuel pump collision switch and clutch in and key start, the started, as quickly as released the switch it stop running, shows up to be switch eh, where to get brand-new one, assist thanks.
*


mine 1987 ranger would certainly not start. I changed the spark plugs, wires, distributor cap/rotor, and ignition coil. Upon additional torubleshooting, I found that the inertia switch had tripped but I have the right to not obtain it to reset. Might the switch be negative or does it require electric pwr to reset it?
It must go down when pushed, if it no reset try unpluging it and resetting it.Will the reset when unplugged and also pushed down?
I removed the inertia switch and ohmed that out. The switch is close up door so i assumed that it was good. I viewed the fuel pump relay by placing pwr come it and it opened and also closed simply fine. Ns then take it the advice of one more on the forum and also checked in ~ the fuel rail because that fuel. I pressed the tiny test harbor on the fuel rail and some fuel came out. My inquiry is how much fuel is expect to come out once I press the tiny test harbor on the fuel rail?
thats a very bad test to check out if its getting enough fuel, there is no method to tell how much fuel is coming the end of there.You will must do a push test with a fuel pressure test gauge.
Engine mechanically problem1987 Ford Ranger 6 cyl 2 Wheel drive there is a fuel shut turn off switch on pass floor plank it has a button on optimal of move its up and I cant acquire gas to flow can ns by pass switch? because I can not uncover switch at auto parts keep I dont want 2 spend a lot on truck until I acquire it running and check it the end then I would buy move from dealer so so expensive! have the right to I simply bypass to hear the run?
well you deserve to just cross the connector through a piece of wire, but try pressing the button down, that is the regular position. If the switch is up, the kills the pump.
Engine mechanical problem1987 6 cyl four Wheel Drive hand-operated deserve to you phone call me the place of the fuel shut off switch?
ns am having problems with a new fuel pump no priming. I have actually located a trouble with EEC relay and also am replacing it but, I additionally want to examine the inertia switch. I cannot situate it. Does this model have actually one? If so, whereby is it?
Under right facility of dashboard ~ above firewall. Check out the diagrams (Below). You re welcome let us understand what happens.
Engine Died, favor It Wasn"t acquiring Fuel. Adjusted Filter, No Difference. Reset Fuel Pump, No Difference. Been Driveng v The same Fuel...
The Airbag Light come On In The tool Panel and also Is Blinking A Code, it Blinks 2 Times First, then It Blinks 7 Times The Second...


See more: Should People Should Be Fined For Not Recycling ? Should People Be Fined For Not Recycling

I newly Ran off The Road due to A tires Blowout and Encountered Some turbulent Terrain. 2 Days complying with That, mine Airbag light Came...